First, understand the causes of the leakage at the manufacturer's rod end of the high-pressure cylinder:
We need to understand what the problems are going to be, including many factors. In addition, common elements include:
1. There is an oil drain hole at the head of the oil cylinder, but the connection is timely during installation, which will lead to oil drain.
2. There is the title of "surface oil splash" in the manual arc welding of hydraulic cylinder inlet return tubing.
3. In the welding development process, dust control sequence is adopted due to the large amount of dust other sundries.
4. The cleanliness of the hydraulic oil is enough, there are many impurities outside.
In addition to several major factors above, we should also consider the content in the actual task: due to the hydraulic cylinder manufacturer of relatively high temperature working condition, belong to the high frequency equipment, the outline of the piston rod of oil film outside its accumulation form oil droplets, simply install without installation of drainage channel, long locks, so the oil the shield of rod end leakage problem.
Next, hydraulic cylinder manufacturer rod end leakage problem processing step: need to ensure that the use of hydraulic oil, good quality. In addition, during the installation process, to prevent leakage hazards. During installation use, care should be taken to keep the environment clean, in general, care should be taken to weld in a high dust environment.
Yangzhou maode machinery co., LTD is a large oil cylinder, high pressure oil cylinder, stainless steel oil cylinder, hydraulic cylinder based on the production of physical enterprises.www.yzmaode.com
